alldodge's latest activity

  • alldodge
    alldodge replied to the thread Trim went full up on it’s own.
    Those switches go bad This is up to you, can put new switches anywhere, but I would get into handle and fix.
  • alldodge
    alldodge replied to the thread dual outdrives.
    Check to see if it has trim limit spacers inside the cylinder Scratch that See if the cylinder rod is longer than the out. Run trim full...
    • B3 Trim Blocks.JPG
  • alldodge
    alldodge replied to the thread 3.0L mercruiser compression.
    No way you have blow by with 150 psi, or their gauge is crap Hey @Scott Danforth
  • alldodge
    alldodge replied to the thread Power steering fluid vs transmission fluid.
    No worries
  • alldodge
    alldodge replied to the thread 3.0L mercruiser compression.
    Could throw it back at them Tell them to build you a motor with 180 compression that runs on 87 octane with current prop and drive
  • alldodge
    alldodge replied to the thread 3.0L mercruiser compression.
    Find another shop, the 140 to 150 is golden Look closer at your prop pitch
  • alldodge
    alldodge replied to the thread Bourbon, surprised!.
    I musssstuvve missedddddd somptom, got up off the floor and youzz guyss are askkin bout cutting allsss content or somethin like that
  • alldodge
    alldodge replied to the thread Busbar addition..
    2/0 is direct Bat cable size, so fuse/breaker not needed so much
  • alldodge
    alldodge reacted to jt1313's post in the thread Busbar addition. with Like Like.
    Just read the chart you attached. Thank you very much for the assist.
  • alldodge
    alldodge replied to the thread Busbar addition..
    Depends on what size wire and how long it is Size Chart
  • alldodge
    alldodge replied to the thread Busbar addition..
    No, it's just good practice If your running a smaller wire in addition to Bat cable than even better reason for a fuse/breaker
  • alldodge
    alldodge replied to the thread Engine help.
    Even when in gear? You said What odes this mean? It's in gear and will idle but not increase when throttle is moved, or something...
  • alldodge
    alldodge replied to the thread Engine help.
    Welcome Have a serial number of the motor? What is the fuel pressure? Does it use digital throttle system (DTS) or have a cable?
  • alldodge
    alldodge replied to the thread Merc 250 Verado Fuel increase.
    New Bats and charger and all prior issues seam to not be an issue currently, will need to take out a few more tries to verify. Started...
  • alldodge
    alldodge replied to the thread 1995 Crownline 202BR Restore.
    Boats coming along nicely Don't know about the streaks
Show older items
Top