finally GOT THIS SOLVED. The sealing ring shown in the picture was the correct one for this copper piping to the plastic strainer housing. I applied a little Permatex gasket sealing compound for water pumps to the connection, let it cure for two days and started the old motor up today. No...
does anyone know the dimensions of the sealing ring I am questioning? The one I am using is outer dia. 1.150 " inner dia. 0.860 thickness 0.150
there is a fine cutout on the inside diameter too. LIke a line that is slightly deeper than the inside of the sealing ring if that makes any sense.
AS I thought I had forgotten to put a new sealing ring between the metal top of the HE and the plastic bottom of the strainer housing. That solved the leak at that point.
The connection between the upper part of the strainer housing and the copper tubing that goes to the exhaust is leaking. I...
AS I examined the old strainer housing today, I saw that there was an old rubber sealing ring inside of the plastic housing. I don't know if I replaced a new ring on the inside of the new plastic housing. I will take that new one off the heat exchanger and examine it, and that should be the...
here is a pic of the old parts but new part is the black strainer housing that sits on top of the heat exchanger. disregard the rtv gasket material on the old one. i cleaned all of that off before installing the new strainer housing.
Ran the boat in shallow muddy water and picked up debris in the cooling system lake water side. cleaned it all out and in the process had to replace the raw water strainer housing which cracked UGH. But that brand new housing leaks where it mates to the metal cover on the heat exchanger. I...
Update
I’ve spent too much of the summer diagnosing and attempting to solve the leak and overheat problems. I’ve serviced the heat exchanger and replaced all the seal and gaskets. But it leaks antifreeze where the plastic strainer housing meets the metal top of the heat e exchanger. This is with...
It took two of us to free the cover off the body of the H/E and nothing broke! Previous owner must have taken this thing apart and used some kind of sealant on the gasket that did not budge until I applied some heat. Now I’ll get the insert cleaned out, clean up the mating surfaces and new...
I got the white plastic bushing off but that top part is still not coming off. It seems like the top cover part is attached to the insert and all of it should come out in one movement? This is crazy.
I had the putty knife in the crevice all around but it’s not moving and yes I’m afraid to snap a piece of it. It’s over 40 yrs old!
I’m gonna try to see if the top will rotate around the white plastic and metal pipe.
I’ve tried screwdrivers, putty knife, even a pry bar for taking moldings off. These pictures show how much that cover moves then nothing. I wonder if the white bushing is holding it up? I don’t want to mangle that though.
Those bolts were easy to get the whole unit off the boat and the bolts holding the top plate to the unit weren’t bad either. Not sure how much persuasion should be used to get the cover off.
Thx. Any tips on getting the top plate off the heat exchanger so I can get at the wafer type of strainer inside? Right now I’m soaking the top plate joints in PB BLASTER to loosen it from the body of the H/E. The entire H/E is on the workbench. I’m talking about the metal top plate the plastic...
