Helps to cut out the middle. Attwood buys that light along with sea-dog, perko, etc., and its stainless.
the OP's light is just an aluminum tube transom light from Perko
plenty out there up to 61" that should plug into his socket.
here is a 54" with a 3-pin base.
A is your gauge sender. It only controls the gauge
B is the wire off the oil switch
C is the oil fitting for the oil switch
The switch between Band C is a binary mechanical pressure switch
Your measurements are meaningless
You should be looking for a bad connection, most likely the block...
It's normally just a section of smaller square tube.
For example on 1-1/4" 1/8 wall, a section of 1" square tube is used as the connector
So for 1", the two square tube sizes to use would be 3/4 or 7/8 depending if you have 1/16 wall or 1/8" wall bow tubes
if its held on with clips, there will be one or two locking screws. look in the drain holes (if equipped) or under welting. then slide the panel the opposite direction of the lock screws
if its held on with christmas tree fasteners, then just pull. however sometimes you break things doing...
most of the deck hardware is bolted on BEFORE the cap goes on the boat.
you will most likely need to cut an access hole for a quick fix or like I had to do to tighten the aft hand railings on my boat. pull the motor to get room for my fat body to get access to use 2 feet of extension and a...
Dowco, Great Lakes Boat top, Tumac all make canvas for variety of OEM's if the top came from the OEM.
if the top was aftermarket, many are coming from Homful in China/Cambodia/Mexico to be sold on the market (and Amazon)
any local canvas shop can make a new custom fit top
sounds Orwellian dystopia meets Elysium meets the movie passengers.......
we could put the Bezos and Musks of the world on it and hope for a hurricane.
