Recent content by Chuck4741444

  1. C

    1996 johnson 200 running Rough.

    I found the problem with rough I have plenty of for fire, I pulled each wire off one at a time running, stuck a screw driver in it and held close to ground . Jump 1 inch and sounds like LIGHTENING!!!!! the cause of the rough running was water in the fuel, I had water in it last year, so i...
  2. C

    1996 johnson 200 running Rough.

    The oil / fuel pump is deleted.
  3. C

    1996 johnson 200 running Rough.

    I did it, took it out to the lake and ran it hard, running great. I set the float to make the difference, if anyone ask you, be sure to tell it works just fine.
  4. C

    1996 johnson 200 running Rough.

    This motor has the oil deleted, it running pre mixed fuel.
  5. C

    1996 johnson 200. Carbs question

    I used them, set the floats, the float has plenty of travel up and down,
  6. C

    1996 johnson 200 running Rough.

    The hoes is an1/8 from the front lower of the crankcase. The floats were set, the carburetor comes off without disturbing the linkage , its all connected on the throttle plate.the throttle, Ill check the spark gap, And make sure coils are firing, the one thing I may have done is i used the...
  7. C

    1996 johnson 200 running Rough.

    I have a 1/8 vacuum line coming fron the crank case, I plugged it, I dont know where it should go. Could the electric primer be letting fuel through it? The did have the purple white wire disconnected, i added a plug and reconnected it, it doest can the rough running either connected or...
  8. C

    1996 johnson 200 running Rough.

    Motor new to me, it running rough, I have rebuild carbs, clean the holes in the throttle plate, stars and runs easy. I have sprayed carb cleaner on the carbs, throttle plate and the intake manifold. Crank case seal, check for loss fuel lines, I cant find an air leak, I pulled the plugs and...
  9. C

    1996 johnson 200. Carbs question

    Im rebuilding a set of carbs, the old needle set doesn't have the white seal, but the kit includes it. I just readjusted the float. Does it matter as long as the is set?
  10. C

    Mounting bracket for j200

    The top bolts are 3/8 to close that 3/16 each side. I built a rack to hold the old motor today, I believe the bolts with have enough slack, I can split the difference between the new bottom holes and the top. Thanks guys, I believe i was over thinking it. I just didn't want to drill and plug...
  11. C

    Mounting bracket for j200

    Thanks. Ill file them larger.
  12. C

    Mounting bracket for j200

    What do you think about milling the 2 top holes ovel? Would it weaking the brackets?
  13. C

    Mounting bracket for j200

  14. C

    Mounting bracket for j200

  15. C

    Mounting bracket for j200

    Im changing motor for a 90 160 to a 96 200. I had to add a 5" life kit for the 25 inch shaft, the pictures im post sh I w the measurements. Its off by 3/8 , will the bolts have enough play to compensate for it?
See more
Top